Differences

This shows you the differences between two versions of the page.

--- tech:sugablureplacesim [2024/08/19 17:01] – admin
+++ tech:sugablureplacesim [2024/08/20 07:26] (current) – admin
@@ Line 28: / Line 28: @@
 ===Open the baton===
 The baton has been designed to be replaced once opened. However if you do not have access to a new casing you can open the baton carefully and temporarily use the same baton casing when finished. Gently use a plumbing pliers to squeeze the baton near the front where it is attached and break the glue by gently squeezing and turning.
+{{:tech:sbopen1.jpeg?direct&400|}}{{:tech:sbopen2.jpeg?direct&400|}}{{:tech:sbopn4.jpeg?direct&400|}}
 ===Take out the board===
@@ Line 33: / Line 34: @@
 ===Replace the SIM card===
-Remove the glue from the SIM card. Do not lift the SIM card off the board as the holder will be damaged. Once the glue has been removed pushing the SIM card in will take it out. A new SIM card can be pushed in place of the old one.
+Remove the glue from the SIM card. Do not lift the SIM card off the board as the holder will be damaged. Once the glue has been removed the SIM card by sliding it out. A new SIM card can be pushed in place of the old one.
+{{:tech:sbsim.jpeg?direct&400|}}{{:tech:sbsim2.jpeg?direct&400|}}
 ===Place the board in a casing===
 Place the board back in a casing. Ensure the board slides along the rails made for it. The LED at the back should be facing the keying.
+{{:tech:sborintation.jpeg?direct&400|}}
 ===Set the APN of the SIM card===
@@ Line 44: / Line 47: @@
   * The cell phone number of the SIM in the baton
   * The APN details of the Service providor "internet"
-Send the unit a message via sms formatted as follows. AFter sending the SMS wkae the unit up by clocking a point.
+Send the unit a message via sms formatted as follows. After sending the SMS wake the unit up by clocking a point. "Magcell" is case sensitive
   Magcell:A00123:*:*:*:internet:*:*:*:*
 ===Test the baton to make sure its working===
+Login to the server, go to Signals report and use the serial number to see any signals sent by the device. You can also go to your profile and refresh the page to see if the unit is communicating with the server.
 ===Seal the new casing===
+We provide a special sealer for the batons, however super glue can be used in a pinch. If you are reusing the casing temporarily tape will also work. We have found that Self Amalgamating rubber tape will still keep the baton sealed.